- H and s mini maxx dpf delete tuner unmarried spot install#
- H and s mini maxx dpf delete tuner unmarried spot update#
Connect one end of the USB cable into the port on the side of the OBD box and the other side to the green connector behind the dash into the 5th port down on th e connector closest to the driver's seat. You will only use this OBD box on the 18+ RAMs.
H and s mini maxx dpf delete tuner unmarried spot update#
To update your tuner is free and then you will need an MCC unlock to go the rest of the way. Replace the OBD box that comes with the Mini Maxx with this bypass version with the red stripe. That will work just fine just make sure it is not VIN locked.This bypass cable comes with a replacement OBD Box and USB cable.
You m ust use this bypass cable or you can corrupt your PCM. I hadnt planned to even use the tuner for HP, though im considering a tow tune. The information listed is for tune file versions used by the 6.6L Duramax LML / LGH. *2018+ RAMs require a bypass cable (#42215). I just ordered the H&S Mini Maxx, as well as a turbo back exhaust replacement, and an EGR delete kit for my 6sp manual drw 3500 6.7L. The following is the change history log for Mini Maxx Tuners that was previously hosted by H&S Performance before they closed down. The EGR system must either be fu lly removed or at least disconnectedįord & RAM - Unplug the throttle valve in the fully open position Leave any sensors in these pipes and disconnect the connectors. Once powered on, just follow the on-screen instructions until the installation is complete.Īfter the tuner has been installed, you can start the engine and let it run for 15-20 seconds just to verify there are no error messages or CELs.Īfter confirming there are no issues, you will need to physically remove the DEF/DPF/SCR section of the exhaust.
H and s mini maxx dpf delete tuner unmarried spot install#
Make sure you do not have any emissions-related error messages on the dash these messages can only be cleared with the truck 100% stock.ĪLWAYS install the tuner before installing any hard partsĬonnect your battery charger, then connect the tuner. You will need a battery charger capable of supplying at least 10A steady without this, you risk damaging your PCM. You must remove the emissions systems after installation. does this tuner have to be hooked up all the time or can it be tuned then taken out of the truck View answer. It went bad, will this correct the proble View answer.
The Mini Maxx V2 is a delete-only tuner designed for off-road, race, and agricultural use. I paid someone 1600 for a DEF and DPF delete.
0 kommentar(er)
